I replaced the old link with the new one where the name of the project is

But in any case, here’s the full link https://github.com/BaldissaraMatheus/Tasks.md

Sorry, I think you opened the wrong app, as I didn’t included the link before and lemmy rendered the page with an address to another website :p

The right one is this https://github.com/BaldissaraMatheus/Tasks.md

Updated, sorry for not including it before

It’s not! Sorry, I reposted from reddit and didn’t notice the link didn’t come with it

Removed, I reposted it from reddit and this text came with it

Thanks for pointing out :p

Right now you can add tags to cards, but you can’t group vertical lanes. Though a do plan to add groupings or epics eventually, it would actually be very convenient by its current architecture.

Yeah I consider adding caldav support eventually, but I need to read about it a little more and experiment a bit to see how much complexity it would add to the project. I really want to keep it as simple as possible in regards to both setup/installation and how it works, so I need to evaluate it properly to see if it’s worth it or not

Yeah I plan to add it eventually, thanks for the recommendation I’ll keep it noted!

No, it does not support push notifications yet

Hey, I didn’t know about silverbullet until now, I’m gonna take a look about it when I have some free time!

No, right now there is no alerts and no way to assign due dates to the tasks

Thank you! 🙂

Might be a network issue, check your upload speed. I had similar problems and the issue was that I was using a cat5 cable on my server, which was limiting the upload to 100mb, causing it to stutter while playing videos with high bitrates

Yeah it’s not like Roku/Chromecast/fire stick do that too, only the Chinese ones, right?

Use FabBlock

I’d need to check it out, it’s been a while. But I tried pretty much all addresses that are printed out with “ip address” command on linux

Yeah I set it up to forward 80:80 and 443:443 but it didn’t seem to have any effect. Does port forward work on ipv6 the same way it does on ipv4?

I tried that and couldn’t make it work. My server was unable to receive any http requests. Then I tried doing some tweaking in my ISP router configuration but with no success. So far cloudflare tunnel was the only solution I found

Tasks.md because i made it, it’s docker based and quite easy to setup